|
Ages 5+ |
Time 45–60 min |
Level Intermediate |
Materials About $15–20 |
This build uses three tools in one project: a screwdriver for the eyes and buttons, a wrench for the arms, and a tape measure to lay it all out. When it's done, the arms swing on a real bolt.
Handy Famm Tools You'll Use
- Phillip the Octopus Phillips-Head Screwdriver – ratchet action and stabilizer legs
- Bolt the Blue Hippo Wrench – adjustable jaw
- Any Handy Famm tape measure
- Lola Kids Safety Glasses
Materials
| 2x4 pine, cut into one 6" piece (body) and one 3-1/2" piece (head) | ~$4–6 |
| 1x2 pine, cut into two 5" pieces (arms) | ~$2–3 |
| 1 hex bolt, 1/4" x 6", with 2 washers and 2 nuts | ~$2–3 |
| 1 wood screw, #8 x 2-1/2" (attaches the head) | ~$1 |
| 5 Phillips pan-head screws, #8 x 3/4", and 5 washers, about 1" wide (eyes and buttons) | ~$3–5 |
| 1 small screw eye (antenna) | ~$1 |
Prices are approximate and vary by store. Bring your wrench to the store and check that it fits the nut before you buy.
Grown-Up Prep
- Have the store make the cuts, then sand the edges.
- Drill a 1/4" hole straight through the body from side to side, about 1" down from the top, and a 1/4" hole through each arm about 1/2" from one end.
- Drill pilot holes for the head screw, the eyes, the buttons, and the antenna. Start each screw a couple of turns so it stands up on its own.
Step-by-Step
1. Lay it out
Stand the body up. Use the tape measure to mark the center of the front face. Mark three button spots down that line, about 1" apart.
2. Attach the head
Set the head block flat on top of the body. Safety glasses on. Drive the long screw down through the head into the body with the screwdriver. The ratchet does the work – just keep turning.
3. Add the eyes and buttons
Slide a washer onto each short screw. Drive two into the front of the head for eyes and three down the body for buttons. Stop when the washer is snug.
4. Bolt on the arms
Put a washer on the bolt and slide it through one arm, then through the body, then through the other arm. Add the second washer and thread on a nut by hand. Hold the bolt head still and tighten the nut with the wrench until the arms are snug but can still swing. Add the second nut and tighten it against the first so nothing loosens.
5. Add the antenna
Twist the screw eye into the pilot hole on top of the head by hand.
6. Name your robot
Paint pens and stickers finish the job. Every robot needs a name.
Safety Notes
- A grown-up does all of the drilling.
- Safety glasses on while driving screws.
- Keep fingers clear of the wrench jaw when it's turning.
Make It Your Own
- Add legs: two more 3" pieces of 2x4 bolted to the bottom.
- Use nuts glued on as a nose and ears.
- At a party, pre-drill every kit so each kid builds a robot in under an hour.
Share Your Build
Post your robot and tag @handyfamm. We feature community builds right here.
Need the tools? Shop screwdrivers and wrenches, or see all gift sets. New to building? Start with How to Host a Build and Play Party.

